Wanted: A few CMP parts

[Bob Carriere]

Hi Jordan

The sheet metal dust covers are available from LWD I beleive...

The funny funnel oil catcher is available from Macs auto standard Ford item

The cast parts were made just fro one week in July 1940 of unobtenium.

I have seen some stamped metal ones used by civilian models but remember where......

On my C15a because I was using the 2 speed T case I made and installed sheet metal cover plate over the hole..... both of mine where broken.

Best bet would be used parts....... and they are a bitch to remove unless you are going to torch everything..... have you considered Dennis near you..... you might have to offer carefully remove them yourself....but you could find the other parts at the same time... by design they are weak parts easy to break off.......same for the other end of the cable where it attaches to the frame.

There is a cut out drain hole in these rear seals..... they eventually fill up with mud and rust starts....make sure the rectangular hole is clean and open to drain out the back of the backing plate.

I can check the spare axles I have in a few weeks if the snow ever melts.....

Good luck