British Vehicle New Guinea

[Phil Waterman]

Originally Posted by Lang

Thanks for that Maurice I knew there had to be some sort of safety feature.

It is amazing how difficult it is to get a vehicle seriously bogged like this out of a hole. The winch may be able to lift the truck if you had a sky-hook but dragging it horizontally is often another matter. Finding something to hook the cable on to is also a common problem - I doubt a coconut tree would hold 7 tons. The back looks as full as a Catholic School bus so probably 14 tons might be more like it?

Great info on another fail-safe system.

Lang

Hi Lang

I'll look for a picture in a recovery manual, which shows using logs to lift a truck out a ditch with a winch. Basically it shows standing the log on end with winch cable over the top. If remember the photos/drawings correct it shows it being done the a single log straight line pull essential or two logs as trypod which makes more sense.

As to safety point on winches like found on CMPs I think the primary safety factor on over loading the winch is between the operators ears. Having used the winch on my C60L Pat 13 a lot I'm convinced the winch is quite capable of folding the truck into horseshoe, or at least bending it to the point where the winch drive shaft pops out.

Had the occasion to use the winch on my truck in with some current duty service men and they were quite impressed with the fact that the cable could be run out front or rear, but when the winch started pulling a heavy tree snag wit the engine ticking over at idle.

Cheers Phil