Staghound hull MG casement?

[Jack Geratic]

Hello Marco, thanks once again for your help.

This second diagram you have posted is quite informative. The base width of the glacis at it's bottom edge has Bronco's kit only short by @ 0.65mm - I can live with that.

The other unit value of 245mm is interesting. That scaled down @ 1/35 is 7mm, while the Bronco measure is only about 5mm. This doesn't necessarily mean the kit part is short by 2mm, could be just the angled section above it is wrong or a combination there of.

Difficult to tell exactly because your drawing has been skewed in perspective, but it seems the mg mound is basically square shape at it's base- so it's height and width should be equal?

Only three more measurements and then, I think, this can be put to rest. Any values to input for below?

final measurements.jpg


regards,
Jack

[marco]

Jack,

Hereby the dimensions you are looking for.
The base from the mg mount is nearly square, the vertical dimension being slightly less than the width.

Marco

[Jack Geratic]

Marco, still more thanks to you for all your help. Here are the additional measurements in light blue bars;

Gt0AaMN.jpg

Have raised slightly the mound and compressed it's height to reflect the new information. It's final height though is with a question mark.

Overall glacis height could have 0.5mm added but not really necessary - only if one wants a bit more space for the markings, in which case I would add that at the bottom edge.

The headlights are also very close, only 0.7mm off when measuring from their centers.

regards,
Jack