|
|
#11
12-04-19, 00:22
|
||||
|
||||
Front drums went back on and then I followed the bearing pre load steps in the manual. After installing the wheels I can feel very very very minor rocking in the right side. The left side has no rocking at all. I’m thinking the drum may not have fully seated on the splines.
92F9F2DB-3BB6-4DC0-A6F9-FCBD60216185.jpeg DA5400C0-44AB-4EB2-A96F-E033B3D2D206.jpeg F82F3F5B-36F9-4E32-A781-B965AC89F17C.jpeg Lastly I’ve got all the original brass brake junction blocks to go back on. Any suggestions on cleaning these up? I’m thinking that sandblasting them will be to hard on them? C8406251-5E59-46A6-A9BF-3A0356CDBB93.jpg 5CFB348F-AC08-41FC-BA0F-937CAFE80DE9.jpg
__________________
Jordan Baker RHLI Museum, Otter LRC C15A-Wire3, 1944 Willys MB, 1942 10cwt Canadian trailer 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 1944 C-15A-Wire-5 Restoration | RichCam | The Restoration Forum | 706 | 18-05-23 02:43 |
| Sold: 1944 Chev C15A Wire-3 | Don Dingwall | For Sale Or Wanted | 11 | 02-04-15 23:26 |
| What was once 2, is now 1. (C15A-Wire-5) | RichCam | The Softskin Forum | 3 | 30-12-11 22:49 |
| photos needed for c15a wire 3 van body | jason meade | The Softskin Forum | 5 | 10-08-11 06:29 |
| Wire loom for C15A Cab13 | Jordan Baker | The Restoration Forum | 19 | 28-08-06 03:42 |
Threaded Mode