|
|
#12
23-09-19, 22:40
|
|||
|
|||
Solution - Have a whole new drive shaft made
Hi All
Well the solution I've decided to go with was to have a whole new drive shaft made. Which I picked up this morning, all new Spicer components, I painted it to match the truck this afternoon. Note to self, if I do this again ask the shop not to paint the drive shaft, it took more time to remove the rattle can paint, then it took prime and paint with good enamel paint. After I've installed it and road tested it I'll share all the part numbers and details, like cost and pictures. Cheers Phil
__________________
Phil Waterman `41 C60L Pattern 12 `42 C60S Radio Pattern 13 `45 HUP http://canadianmilitarypattern.com/ New e-mail Philip@canadianmilitarypattern.com 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Chev 216 loose piston pin - which one ? | Mike K | The Restoration Forum | 84 | 10-02-18 00:52 |
| Wanted: Diamond T rod ends | McDell Bros | For Sale Or Wanted | 3 | 16-03-15 10:58 |
| Tie Rod Ends | Alan Nicholas | For Sale Or Wanted | 3 | 31-12-09 12:48 |
| Axle Ends | Vic Eaton | The Softskin Forum | 0 | 06-04-06 21:38 |
| Buckle ends for webbing | Maurice Donckers | The Carrier Forum | 4 | 04-03-05 08:01 |
Threaded Mode