|
|
|
|
#1
04-10-19, 17:16
|
|||
|
|||
My box is Canadian, and I don't know who made the internals. While, for the most part, they do match up, the top tray is a tight fit into the main box. I squeezed it into there for now, but will do some fitting once I get to that part of the 25 pdr project.
|
|
#2
04-10-19, 21:24
|
|||
|
|||
|
As promised, some photos of the tray interior.
As I mentioned, my box is Cdn and the internals came from Oz. While the mounting comes pretty close, there are variations. There would seem to be a variation with the bracket that limits the lid, as I am going to have to relocate it's mounting point. Over the years, some of the wood screws that Jack kept with the dividers may have become misplaced or used up elsewhere. I have a lot I removed from Bren chests, so managed to replace some of the missing ones, but I am going to have to dig a little deeper to find some of the smaller ones. I note there is also a wooden cover to go over the face of the pressure gauge that is missing in your photos Rob.
|
|
#3
04-10-19, 22:31
|
|||
|
|||
|
That's fantastic Rob ,just as I have in the line drawings ,I do have the pressure gauge covers and they have a round horse hair padding glued to them.
Rob...……………...rnixartillery.
|
 |
|
|
Hybrid Mode
