Calling Rob Love or others with info... Jeep F-head engine

[Bob Carriere]

Spent another 4 hours listening to pops and whomps and other spit back from the carb but will not start..... driving me nuts.

Engine is military rebuild and we heard it run last spring in the crate.

Oil pump was not removed so the timing should be the same. Checked voltage to dizzy, lightly dressed the points with a Nichalson ignition file, points spark nicely, contacts in cap and rotor were cleaned to shiny brass. Set engine at 5BTDC....... rotor pointing at number 1......... re-instal dizzy cap.....checked spark at plugs.......cranked pooff pooff. Disconnect fuel line at carb....crank engine....lots of fuel coming out......
I am having the owner crank it with ignition switch on while I slowly maneuver the dizzy back and forth within the range allowed for timing....... hoping that once it starts we just need to tighten up the dizzy nut after some final adjustment.

I have always used this method on the Chev 6.....once it runs I can adjust to its particular sweet spot.

What the hell am I missing.......?

Since we are working inside a wood heated garage I have restrained myself from using ether....my favorite gogo juice....... BUT have squirted raw gas in the intake...... poof poof..... fire ball but will not run.

I have been known to blow up M37 mufflers with ether....blows up real good and opens up the side seam wide open.

Why won't it run?????