![]() |
|
#12
|
|||
|
|||
![]()
Guys,
Ever since I had an incident of front wheel shimmy after hitting a bump at speed, I had become uncomfortable on how I had set the front wheel bearings. With Robin's assistance, I was able to persuade Gerry Foster to visit and reset the front wheel bearings "by the book". Next on my list is to have the wheel assemblies balanced by a heavy truck shop. Now looking forward to this spring's first run. On a cosmetic note, I was able to source original hose clamps from Early Ford, SC. Took a total of 16, but the engine compartment certainly looks better. Peter IMG_2156.JPG IMG_2161.JPG IMG_2162.jpg |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Lynx Hull number? | James Gosling | The Armour Forum | 3 | 17-08-15 08:28 |
At last here are some photos NZ LP hull | Lew Skelton | The Carrier Forum | 12 | 29-04-11 10:22 |
Hull # | gary_bath_jr | The Carrier Forum | 5 | 12-07-10 20:31 |
Welded hull | martyn | The Carrier Forum | 14 | 15-03-10 13:02 |
UC Hull | Richard Coutts-Smith | The Carrier Forum | 14 | 08-04-08 01:25 |