Ferret Distributor

[Richard Coutts-Smith]

Ok, PM me an address and I will put it in the post if it looks OK.
Rich.

[Ed Landstrom]

The Ferret Club (Oshawa Museum, Ontario Regiment) has published instructions for fitting a Chevy distributor to a Ferret engine. That was what I did when I discovered that a rotor was going to cost $200 and take a month to arrive from England. I had the necessary distributor in my scrap box and it only took a few hours. They're as common as dirt here. Maybe over there they're called Holden. It works fine, as long as you don't insist on originality. I should have the instructions somewhere, but you can probably find them faster on line than I can in my files.