Shipping Container Parts Storage Layouts

[Lang]

Lionel

I have 3 containers;

A 20 footer with 3 foot shelves along the back for larger items. I park my Jeep in this.

Another 20 footer same shelves with my FIAT Spider

A 40 footer with 3 high 2 foot shelves running along one side starting about 6 feet in from the door. They finish about 6 feet from the end. Across the end there are racks for smaller (jeep and car size tyres). On the right side along the wall are my truck tyres - lots of truck tyres. You could make these more shelves if you did not have tyres. Make sure the first shelf is at least 2' 6" off the floor if you are trying to store heavy axles and gearboxes to get reasonable "grunt" space.

This gives about 2' 6" passage. The reason for starting my shelves in from the door is to give a full width area for any large junk to be brought in and maneuvered or just to put stuff out of the weather temporarily.

The advice to roof the container is very sound as the cheap ones you buy often leak. Some old roofing sheet on a couple of 4x2 pine supports running the full length (Bolt or tie it down!) gives water protection but more importantly drops the temperature as I have measured a sealed one in the sun on a hot day at 65 degrees which will not do rubber etc much good.

Now the real winner. Get yourself a whirly-bird, they are very cheap if you look around. Cut a couple of holes about A4 size in the far end low down. Put some mesh or something over them to stop snakes and other creatures getting in. Put the whirly-bird on the roof near the door end.

This gives you full container circulation and even on the hottest day, inside will be very similar to outside temperature. Most importantly it eliminates sweating and subsequent corrosion that is a real problem with sealed containers.

Here is a photo for people who call a whirly-bird something else. Also a photo of my place with the shed and 3 containers out the back, bottom left two 20 footers with a truck parked between them, north side of the shed the 40 footer with a truck body on top of it. - no problems with Moreton Bay City Council.

Lang