|
|
#34
29-09-20, 20:51
|
||||
|
||||
The copper is 35mm plumbing tube pressed over nylon insulators with the relevant wires soldered in.
All the external connectors that i have used are clansman but i couldn't find a female socket, so i used a bulkhead fitting and turned up a two part housing that pushes together and sealed it all by covering it with heat shrink. The outer housing has a bearing top and bottom and an oil seal at the top to stop dirt getting in but i forgot to take a photo of the completed unit. The whole unit is housed in a fabricated steel enclosure that will be sealed with silicon on final assembly.
__________________
1950 Land Rover series 1 1967 Land Rover series 2A LWB 1986 Land Rover series 3 SWB 1938 DKW SB200 1944 DKW NZ350-1 1967 Ural K750 sidecar outfit 1944 VW Kubelwagen KDF82 1942 Steyr 1500A 1944 Morris C8A 1943 Chevrolet CMP8A HUP? 194? Bedford QL 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Armour in the Rhineland | John McGillivray | The Armour Forum | 1 | 05-11-11 20:04 |
| Armour id needed | BSHEVLIN | The Armour Forum | 2 | 18-06-09 05:21 |
| Old Armour in service | matilda IIA | The Armour Forum | 19 | 11-03-09 12:11 |
| Armour i.d. | David_Hayward (RIP) | The Armour Forum | 8 | 14-09-07 11:27 |
| Tim Tam Ice Creams!! | David_Hayward (RIP) | The Sergeants' Mess | 2 | 23-09-05 04:08 |
Threaded Mode