Wireless Set No. 52 Canadian - Project

[David Dunlop]

I managed to get the bottom two PLATES cleaned and re-plated this morning.It went a lot better for some reason than the upper two, as I get an excellent, uniform plating with the first attempt this time.

One hardware set had to be replaced as it was a differing thread type than it should have been and the screw was a cheese head slotted/Robertson combination head that was definitely a replacement at some point in the Sender's history. Fortunately, I had backup hardware from the spare receiver.

The two lower PLATES were mounted this evening and I now have to give some thought on how to proceed with reinstalling some of the knobs and handles. A little bit more research required there as well, but slowly I am making some progress.

David