Wireless Set No. 52 Canadian - Project

[David Dunlop]

Just a bit of a way point in the continued direction of this project.

To recap this photo, the original dial to the Sender is the one on the left. All three dials look that bad. the one on the right is the one to be used on the Sender. It was off the Parts receiver.

The original dial is going to become a test bed of sorts. According to what I had read on electroplating, plating metal will not adhere to a cathode item at all if it is not meticulously clean. The existing adonized and painted dial has darkened somewhat over the years but is not that bad. the zinc plating around the rim and central dial plate is another matter. What I am curious about is what will happen if the rim and central metal are carefully cleaned back to good metal and I then electroplate the dial. In theory, no new metal should transfer to the painted section at all. Only the centre, back and rim of the dial, along with the four small rivet heads.

I am going to try it out and see what works and does not. It may be a useful restoration process for the other two remaining dials.

David