|
|
#14
15-03-05, 01:43
|
|||
|
|||
Pulling hubs and drums against brakes
Yes, pulling the hubs and drums can be fun. I modified a socket so that it will take off both front and rear axle nuts. http://www.canadianmilitarypattern.com/Tools.html Then to pull the hubs and drums I use a big wheel puller that bolts down to three of the wheel studs then pulls the drum and hub off with a big center screw shaft. As I apply force to the center puller, I keep hitting the brake drum fore and aft with a big rubber mallet. Used the same trick on the Pattern 12 recently was successful in pulling all four drums with minimum of problems and without damaging the brake shoes or anything else.
__________________
Phil Waterman `41 C60L Pattern 12 `42 C60S Radio Pattern 13 `45 HUP http://canadianmilitarypattern.com/ New e-mail Philip@canadianmilitarypattern.com 
|
|
|
Threaded Mode