![]() |
#4
|
|||
|
|||
![]()
Hi Mariano,
Always glad to help. Would be a good idea to add an inch either end and then trim to suit. In fact, you may need a few extra inches on the cylinder head end for the bending machine to have something to work with. It is a lot easier to cut off a bit than try to stretch a tube! Cheers,
__________________
F15-A 1942 Battery Staff Jacques Reed Last edited by Jacques Reed; 03-05-21 at 03:59. Reason: Corrected: should be bent end at cylinder heads, not radiator |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wanted: ford cmp radiator | Harlé Sylvain | For Sale Or Wanted | 0 | 12-07-18 21:59 |
Wanted: Ford Cab 11 Grille and radiator | aj.lec | For Sale Or Wanted | 12 | 19-07-13 09:44 |
Loop on fuel pipe on ford f15 ...f60 | serge | The Restoration Forum | 4 | 03-11-12 20:44 |
Ford Holley Carb on V8 - pipe over choke? | Lauren Child | The Restoration Forum | 3 | 07-10-12 14:39 |
Ford Blitz Radiator | Grant Bowker | For Sale Or Wanted | 0 | 04-06-07 00:20 |