|
|
#11
30-07-21, 01:19
|
|||
|
|||
Derk,
Above you queried if C01T 17081 was adapted from a Ford commercial jack handle. I believe that it likely was but I don’t know the original part number or application. My C01T 17081 is not original, but I added the bends at the end to match an original. What I started with was what I presume to be a Ford commercial handle which was identical in all respects less the offset bends. I have also seen examples of these commercial handles with round vice square holes. Last edited by Colin Alford; 30-07-21 at 01:21. Reason: Added sentence 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Four Ton Auto Specialties Jack and Handle | m606paz | The Restoration Forum | 25 | 25-03-24 17:54 |
| Dingo Jack Handle ? | Andrew Rowe | The Armour Forum | 8 | 30-05-16 23:24 |
| Jack Handle | B. Harris | For Sale Or Wanted | 0 | 06-01-11 00:28 |
| Repro Bren Gun Carrier jack handle | Darrin Wright | For Sale Or Wanted | 3 | 02-04-08 18:14 |
| Aust jack handle measurements required | Darrin Wright | The Carrier Forum | 1 | 18-10-07 00:49 |
Threaded Mode