Wireless Set No. 52 Canadian - Project

[David Dunlop]

Here is the little mystery bit of Bakelite that was found in the Connectors socket assembly.

The curve of the piece matches that of the shattered rim around the central Clamping Screw hole. The wide end is actually a finished rim and the overall length is very close to one-quarter inch.

If the central Clamping Screw hole was formed with a quarter inch long tube projecting towards the front cover plate, then the half inch long threaded tip of the Clamping Screw would actually enter this tube before the threaded tip of the screw exited the front cover plate completely. The Clamping Screw would then slide smoothly towards and into the front panel of the Supply Unit.

As it currently stands, once the Clamping Screw clears the front cover panel of the Socket Assembly, it wobbles around enough that getting it into the hole at the back of the socket can be a bit of a challenge.

Be nice to see the insides of some other Connector Socket assemblies to see if more parts or a tube have survived, or even, perhaps a complete tube.


David