Wireless Set No. 52 Canadian - Project

[David Dunlop]

A bit of an ‘Errands Day’ today, but I have managed to remove the Vibrator Supply from the Supply Unit. A simple enough task as one just removes the two drop leads from the front clips, unlocks the two Cowl Fasteners and pulls on the handle.

In Photo 1, you can see the two side flanges of the inner sheet metal case for the chassis of the Vibrator Supply and at the back bottom, the small square cut-out in the case that allows the three banana plugs to connect with their sockets. These are the +12 Volt and Ground Input Feeds and the +150 Volts and Common Ground outputs.

In Photo 2 you have a side view of the Vibrator Supply Cover stuck in position where it blocks access to the right side upper and lower Rotary Transformer Mounting Hardware quite effectively. Note, however, the delightfully clean look of the chassis. Apart from the heavier staining/dirt at the very front and top surface of the chassis , the rest is just upper surface dust. I am being spoiled!


David