SUPPLY Unit ZA/CAN 4772
The Blower Assembly and Fan are now back in the Supply Unit for the time being. I just have to resolder the power feed line to the blower, which I will probably do tomorrow.
The Case for the Vibratory Supply is back where it belongs as well.
As I suspected, some fine-tuning of the front panel of the Vibratory Supply was needed to get it to align with the main Supply Unit front panel. I did that by putting the Supply Unit on its back on two pieces of 2 x 4 wood to protect the two 8-Pin Connectors for the Supply Unit and inserting the Vibratory Supply. By backing off the two SEMS Mounting Screws for the front panel of the Vibratory Supply, and the Knobs, Metal, enough wiggle was created in the front panel of the Vibratory Supply I could get it to drop into place correctly and lock the two Shakeproof No. 18 Fasteners and retighten the three pieces of hardware.
Now I can at least see where the restoration of the Supply Unit is headed.
David
|
06-02-22, 23:14
Similar Threads
Threaded Mode