|
|
#28
28-05-22, 18:55
|
|||
|
|||
This morning was spent marking out and drilling the three holes in the copper bar, for my Ground Terminal Project. The hardware is all ¼-inch brass, but I went to 17/64-inch for the hole size, just to make assembly a little easier.
Once the holes were in the copper bar, I used the bar as a template for getting the two terminal post holes properly centered on the cover of the electrical box. David 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Canadian staff car wireless: World War 2 Canadian R103 Receiver Demo | Mike K | The Wireless Forum | 5 | 24-07-16 15:20 |
| Found: CMP Wireless body project | Jim Burrill | For Sale Or Wanted | 7 | 05-04-15 00:02 |
| Canadian dehavilland mosquito restoration project | David Dunlop | WW2 Military History & Equipment | 9 | 10-07-14 00:51 |
| Canadian project | David Ellery | The Carrier Forum | 9 | 28-04-07 01:36 |
| FOR SALE/TRADE: 1944 CHOREHORSE PROJECT for Signal Corps Wireless Power Unit Project | Alain | For Sale Or Wanted | 1 | 21-02-07 00:11 |
Threaded Mode