Wireless Set No. 52 Canadian - Project

[David Dunlop]

I was hoping the sanding of the front of the Tool Box would bring up more of the factory original stencil but no such luck. I can still see ghosts of some of the information lines as per the Tool Box Geoff Truscott recently purchased here on MLU, to know the layout was consistent with the images in the manuals. The three later sets of markings (all differing from each other) are a bit more legible. Two, along with the factory original are done in a ½-inch high by 3/8-inch wide font. The last and simplest (VAOS Reference Numbers only) is in a larger ¾-inch high by ½-inch wide font.

Similar stencil font software is still available on-line but differs slightly in where and how the individual characters are split to avoid them falling apart when the stencil is cut. That will all need further investigation. In the meantime, I am making notes of how these older stencils were cut for each character to get a better idea of what I am up against.


David