|
|
#3
17-09-22, 19:36
|
|||
|
|||
Lynx Axle
Hi Harry,
To make a new axle, get one from a C8 CMP, and weld up the splines and then get machinist to recut the spline from what was 10 to the Lynx's 12 spline. Cost is about $150 to cut the splines. To match the look on the end of the axle ,just grind the casting knob off. The inner crown wheel hemisphere is from a 1940 One ton Ford truck, only difference there was the Lynx used a 35 tooth crown wheel, Cheers Andrew.
__________________
Valentine MkV Covenanter MkIV Lynx MKI and MKII Loyd Carrier / English / Candian / LP. M3 Stuart 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Rear axle hub nut | Mike Gurr | The Carrier Forum | 8 | 08-01-19 20:07 |
| Wanted: M38 CDN rear axle | Jim White | For Sale Or Wanted | 1 | 15-07-18 22:16 |
| Rear axle help | Ben | The Carrier Forum | 13 | 15-05-13 01:16 |
| Need help Rear axle | Michel D | Post-war Military Vehicles | 6 | 30-05-12 14:05 |
| Needed Driver Side Rear Axle Shaft HUP | Phil Waterman | The Restoration Forum | 9 | 23-06-05 03:57 |
Threaded Mode