Wireless Set No. 52 Canadian - Project

[David Dunlop]

I have completed a round of stencil tests with the brushes I recently purchased. I did not try the 3/4-inch brush as it was far too large for the size of stencil I am using.

The first attempt was the letter 'N' lower centre in the photo with the 1/2-inch brush. Way too much bleed under the stencil on its own so I stopped with the one letter. the next attempt was the test block to the right side with the 3/8-inch brush and the plain stencil. Cleaner, but still way too much paint bleed under the stencil. Both of these tests were done with multiple thin coats build up with the brush.

The last test was the block to the left. For this, I secured the stencil to the test folder with a coat of Rubber cement, pressed the stencil down with a pencil eraser to ensure the stencil was as flat as possible and I let the rubber cement dry for 20 minutes at room temperature. I then rubbed the excess cement off the top of the stencil with my finger and used a round toothpick to clean up any excess cement inside each stencil segment. Then out came the 3/8-inch stencil brush again and multiple coats were build up until the majority of the folder colour vanished.

A very slight bit of paint wicking took place, but overall, I am very pleased with this result and kit will be the process I use with the tool box stencil.

David