|
|
|
|
#1
22-10-22, 12:21
|
|||
|
|||
Excellent work, Harry....and thanks for sharing the info here!
Alex
__________________
Chevrolet C8 cab 11 FFW BSA Folding Bicycle 
|
|
#2
30-10-22, 23:21
|
|||
|
|||
|
end of intermission
Well I got back to work and tacked on the other three 1x3x1 C channels and Sean Black came by and conferred over the welder. Result was I was pushing through .035wire and the welder suggests .030 is the max. So new wire in .030 a proper tip and a new ground connection and my welding improved.
|
|
#3
30-10-22, 23:26
|
|||
|
|||
|
welding and boot step
with the tailgate off I could weld the bottom seam, and bending out the steps and trimming them.
|
|
#4
30-10-22, 23:33
|
|||
|
|||
|
hinges
With the tailgate off I cleaned up the welds on the inside
|
|
#5
30-10-22, 23:41
|
|||
|
|||
|
hooks and ties
fabricated some U hooks and the ties(?) and installed them in the same locations.
then touched up welds, some grinding and then sanded everything especially edges with 60 grit.
|
|
#6
30-10-22, 23:50
|
|||
|
|||
|
closer thingy
Next up was cutting out the holes for the hooks to hold the tailgate closed. the hole is tilted slightly so the more the hook comes down the tighter the gate closes. So it started with thec two holes slightly offset. then using the small air saw to cut out beteween them and the air grinder to finish it off.
|
|
#7
31-10-22, 00:02
|
|||
|
|||
|
hooks
next up was to fabricate the hooks. I used the torch to heat up some 5/8 hot rolled rod and flattened out the ends, then I trimmed them to shape and ground the edges. Then heated them up againand did the u bends. Next was to bend the loop into a link of the chain, I neglected to take a good picture but it shows the before and after in the one picture. Then hung the chain and cut to proper length.
Which i use to hold the tailgate flat, the originals are a few inches longer.
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Fabrication thoughts. | Scott Cacciamani | The Restoration Forum | 8 | 08-10-22 16:46 |
| How To: Fabrication of Wooden 2H1 Body | RichCam | The Restoration Forum | 7 | 20-03-15 02:38 |
| Rear deck fabrication | Dave Schindel | The Carrier Forum | 2 | 18-03-12 21:53 |
| More T16 Parts Fabrication | horsa | The Carrier Forum | 8 | 06-06-07 04:02 |
| T16 Parts Fabrication | horsa | The Carrier Forum | 8 | 14-09-06 17:49 |
Hybrid Mode
