|
|
#5
27-11-22, 06:32
|
|||
|
|||
Hi Rob,
My splash shield arrived today, from Midwestmil. I will give it a spray coat of truck bedliner before trying to install it in my Cdn2. You say that there are 2 bolts on top of the wheelwell, 1 on the inside under the rear seat, and 1 L-bracket that is attached using a bolt holding on the side body reflector. The plate from Midwestmil has 1 additional nut plate on it, it is up higher on the inside above the rear benchseat cushion. Was this one not used? For what ever the reason, my jeep does not have the 2 holes on the top or the inside of the wheelwell. So l need to be careful not to make any mistakes drilling holes. Thanks Richard Mix Jr. CFR 6707832 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| M38A1CDN2 rear light | Retsarge | Post-war Military Vehicles | 2 | 04-11-22 00:13 |
| MkI* U.C. (Canadian) rear panel holes | Lynn Eades | The Armour Forum | 12 | 30-09-18 04:09 |
| Iltis rear quarter panel restoration question | Stuart Fedak | The Restoration Forum | 6 | 09-09-12 22:37 |
| For Sale: Brand New Left rear tail light assmebly for M series | Casey B | For Sale Or Wanted | 0 | 15-05-12 05:56 |
| M38A1CDN2 vs CDN3 rear axle ass'y | chris vickery | Post-war Military Vehicles | 6 | 12-08-11 16:12 |
Threaded Mode