Quote:
Originally Posted by Lynn Eades
Skip your guesses are correct. All BSF of course.
A= 34mm. B= 3/8". Stud protrudes 7/8" (mine goes on side armour)
If you make the collar as high as the lowest point of the sides (make sense?) you will be pretty close.
|
Quote:
Originally Posted by Lynn Eades
Maybe I missed it, but I don't see the opening width dimension in Kevin's drawing, so mine measures 34mm (yes it is original)
Skip, make the stud longer than the photo.
|
on the Ford Canada block, clamping, TL 12851 to fit the glacis plate, the one I measured had a lower portion of the 3/8 “ dia stud extends 5/8” below the block, the upper is 2” above the block. You will not find this part number in the Ford Canada parts books. .
Note the second bolt size: on the Canadian production, 1/4” x 7/8”.
Having had the opportunity to learn about the difference with the brackets from the original Bren carrier, there are slight differences in bolt lengths and size, ie 5/16” vs 1/4”. Thank you Lynn.
Hanno: thank you for maintaining this site, and merging these threads. ����
.
30-06-23, 15:11
Hybrid Mode
