Wireless Set No. 52 Canadian - Project

[David Dunlop]

The handle, hinge straps and corner caps for this case are all identical to those used on the other two boxes/cases forming part of the 52-Set Kits. The thickness of the wooden lid is also the same.

The sole difference in hardware is the two latch assemblies, which although similar in appearance, are larger and of a much more robust design. The first two photos show the standard latch which is 1-3/8 inches wide by 2-5/8 inches long. The second two photos are of the latch used on the Cases, Operating, Remote Receiver. These latches are 1-3/4 inches wide and 3-inches high. Notice the wider clasp and the upper rivet set are installed further down the sides of the bottom assembly. The other significant difference is evident when the clasps are open. The lip of the clasp has a heavy duty tab that engages a corresponding slot in the back of the throat of the catch on the lid. Useful considerations on the part of the designers at Canadian Marconi to ensure this case stays closed when the Remote Supply Unit ZE-12 is inside and the case is being carried over uneven ground. The ZE-12 is a compact size at 8.5 inches high by 10 inches wide by 8 inches deep and yet weighs in at 26 pounds.

I am not sure yet if these two styles of latches, were made by the same company, but I will try and report on that later as more information is uncovered.


David