|
|
|
|
#2
18-10-23, 11:57
|
||||
|
||||
How similar in construction was this mount to the Command & Recce GPMG Kit for the Iltis?
__________________
Tom A in CS WTB: Iltis Cargo Area Floorboards, C9A1 Green Handguard, TICCS Dash Mount; C79 Green Rubber Armor; M72A5-7 LAW Tube; Arid CadPat Rank Slides/Helmet Covers/Pants, etc 
|
|
#3
18-10-23, 15:06
|
|||
|
|||
|
The "Z" arm GPMG mount is very robust, and is similar to the GPMG mount for the observer of the Lynx recce vehicle. The Ferret .30-06 MG swivel mount is again similar but just a bit different.
Not much to be said for the arm except it is 2" or 2 1/4" diameter steel tubing. There is a captured ring and block for the crosspin in place of the pintle traverse and elevating mechanism. The head is a square block with another traverse pin for the front pintle. The final fitting is a flat bar between those two pins which has nubs and teeth to hold a NATO spec' ammunition box. The drawings pages are likely ones saved from Rob and the front view of the mount looks like one of mine.
__________________
Terry Warner - 74-????? M151A2 - 70-08876 M38A1 - 53-71233 M100CDN trailer Beware! The Green Disease walks among us!
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| M31c Machine gun mount | TJ Hall | The Softskin Forum | 4 | 14-06-20 12:12 |
| Inter Acco ? machine gun mount | Mike K | Auction and Classified Ad Site Heads Up | 18 | 06-03-18 08:58 |
| Antenna Mount M38A1Cdn2 | Retsarge | Post-war Military Vehicles | 7 | 09-12-10 18:48 |
| Bren Machine gun mount. | jeff davis | The Carrier Forum | 2 | 06-05-10 07:45 |
| M38A1 machine gun mount. | Al Nickolson | For Sale Or Wanted | 6 | 27-01-08 07:08 |
Hybrid Mode
