COIL, Aerial Tuning No. 2 A ZA/CAN 4725
In retrospect, I overthought this decal work way too much.
I set some time aside earlier today to trim the two decals needed for the Coil assembly front panel and organize ll the tools etc I would need on my bench to get the job done. As I got into it, all the learning from model work 50 years ago came flooding back like the last decals were worked on yesterday. The only two real differences were hand cutting the decals to size and the added step of MICRO SET. and it all worked.
The decals look terrific finally in place and most important they work: glowing the correct luminous green in the dark. I will have to wait a bit to prove that last point. My Canon DSLR has been acting up lately when it comes to "BULB" Time Exposures. One day it works and two days later with the same setup, I get nothing at ll.
I will be letting the decals cure for the recommended 24 hours and then do a top coat over them of satin clear coat.
David
|
Yesterday, 20:55
Similar Threads
Threaded Mode