|
|
#25
22-08-05, 15:54
|
|||
|
|||
Used a 3 jaw bearing puller
For the speedo gear I used a 3 jaw bearing puller, but it needs to be a good one. I pulled the jaw ends right off a cheep one. Loaded the screw with a 10" (inch not foot) wrench then tapped the end with a hammer. Tightened and repeat, as I remember once it let loose initially it came off pretty easy.
Speaking of speedometer gears did your transmission have the shaft gear as well? The Pattern 12 did but neither of the Pattern 13 had one.
__________________
Phil Waterman `41 C60L Pattern 12 `42 C60S Radio Pattern 13 `45 HUP http://canadianmilitarypattern.com/ New e-mail Philip@canadianmilitarypattern.com 
|
|
|
Threaded Mode