|
|
#12
27-01-06, 03:55
|
||||
|
||||
Hi everyone
This thread has become really good from my original comments. Ok this is the setup I have installed in my UC. Ive used steel brake line tubing for the fuel lines. From pump to Carb is a 10" 5/16 line. Would this shape cause me any problems with traping air bubles? Is there any suggestions for improving it. The tank to pump line is the same kind of tubbing but I have also installed an outboard motor primer bulb (thanks Charlie). What kind of fuel filter should I put in or is it needed if I have my original tank cleaned out and resealed/relined.
__________________
Jordan Baker RHLI Museum, Otter LRC C15A-Wire3, 1944 Willys MB, 1942 10cwt Canadian trailer 
|
|
|
Threaded Mode