|
|
#8
02-09-06, 01:37
|
||||
|
||||
Thanks Ken and Darren
Why can't you guys move in next door to me. Woudl be much simpler to pop over in the evening and show me. One more question When I cut the the patch should i bevel the edge of the patch and the surrounding sheet metal so that the weld can fill it up. What I mean by this is that if looking at it as a cross section shoudl the two edges be in the shap of a "V" when they meet.
__________________
Jordan Baker RHLI Museum, Otter LRC C15A-Wire3, 1944 Willys MB, 1942 10cwt Canadian trailer 
|
|
|
Threaded Mode