|
|
#3
20-02-07, 00:02
|
|||
|
|||
Your the second person who needs that drawing
I've been looking for the drawings or in this case full size templates of all the bits and peaces and how to fabricate the side panel. I’ve found all the templates but I trim the parts to fit to much to be of much uses. But I still have both of Bobs panels on the bench next to the one I made so I will sit down with the CAD and see if I can’t come up with a set of drawings for making useable panels. As you can see on my web page http://canadianmilitarypattern.com/SheetMetalWork.html the panel that I made is a good fit but is not an exact copy as I did not have the tools to make up some of the compound curves which were made by stamping the parts.
__________________
Phil Waterman `41 C60L Pattern 12 `42 C60S Radio Pattern 13 `45 HUP http://canadianmilitarypattern.com/ New e-mail Philip@canadianmilitarypattern.com 
|
|
|
Threaded Mode