|
|
#1
23-09-09, 19:08
|
||||
|
||||
flathead timing marks.
hi all, On my flathead 8ba engine i understand there is a timer pointer on the front of the engine to align with the mark on the pulley when no1 piston is at top dead centre, this pointer is missing on mine, you couldnt tell me were the pointer is supposed to be, also what direction does the flathead run in normally?. clockwise?. I need to put my distributor back in and set the timing. there is a hole in the aluminium front case were i guess this pointer should be located but i am only guessing, any tips would be great. even a picture of what this timer pointer should look like.
__________________
2pdr Tank Hunter Universal Carrier 1942 registered 11/11/2008. 3" Mortar Universal Carrier 1943 registered 06/06/2009. 1941 Standard Mk1 stowage Carrier, Caunter camo. 1941 Standard Mk1 stowage Carrier, light stone. 10 cwt wartime mortar trailer. 1943 Mk2 Daimler Dingo. 1943 Willys MB. 1936 Vickers MG carrier No1 Mk1 CMM 985. 
|
|
#3
24-09-09, 05:16
|
||||
|
||||
|
timing
That hole was where the pointer was so just line up the notch in the pully with the hole.
__________________
Model U.C. NO-2 MK II.* SERIAL 25680 HULL 24699. LOWER HULL 24742. ENGINE TL-26707-F. C.D. 2609. BUILT MAR. 25, 1944. CT 266677 Former WASP
|
 |
|
|
Linear Mode
