1946 Chev and Ford Wasco Dizzy tool

[Bob Carriere]

You meet the stangest and micest people when looking for possible CMPs....

Right in the village of Hammond we have a guy wo does a lot of work on old flatty Fords.....

I took some oics of a 46 chev.....same body as a 42 staff car...... last ran in 1957....some one took a wheel bearing off the front axle and a few years later the engine/tranny came out...... but could be converted to a staff car if one was so inclined....asking $500 ........ would be worth while negotiating.

Hew also dug up the specail tool for setting up the points on a Ford flat head.... made by Wasco..... forgot to ask what he wanted for it.... he has another one plus a floor mounted Allen dizzy set tool with special Ford attachements for it...... not yet ready to sell that one.....

I have no personal interest except to share with fellow CMPers.....

Also found what I went there for..... complete early 235 with ribbed valve cover.....Bellhousing to fan, carb, starter, generator..... that one will most likely stay with the barn......

Contact me for his tel. ### you make your own deal !!!

Bob