|
|
#1
29-11-14, 15:53
|
|||
|
|||
Text removed as information is no longer current
Text removed as information is no longer current
Last edited by Stuart Fedak; 23-10-17 at 00:42. Reason: Found 
|
|
#2
29-11-14, 16:50
|
|||
|
|||
|
Stuart
I might have the manual kicking around for the hunter, I'll have a look. They are great heaters....quiet, reliable, and put out reasonable heat. If you are in need of any parts, I do have a small pile of them. I also have a few of the heaters that are spares. One thing to watch for on the hunters (it may be only the larger MH30....the memory is getting a little foggy on these) is that if installing a new heater, they are set up for diesel. There is a fuel bowl warmer on the carb that will boil/vaporise the gas in warmer temperatures.....it needs to be disconnected to use them on gas. There is a wiring diagram in the lids, which was all we usually needed to trouble shoot the heaters.
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Sold: 39-45 Rear Axle Repair Manual -Ford Trucks | Darrell Zinck | For Sale Or Wanted | 1 | 03-09-13 03:01 |
| iltis parts rear wheel wells | jpeters | For Sale Or Wanted | 0 | 22-08-13 23:40 |
| Iltis rear quarter panel restoration question | Stuart Fedak | The Restoration Forum | 6 | 09-09-12 23:37 |
| Looking for manual or excerpt for T16 rear axle overhaul | Hans Mulder | The Carrier Forum | 1 | 31-08-12 22:13 |
| Iltis rear wheel well seats | Wpns 421 | For Sale Or Wanted | 0 | 03-03-10 01:56 |
Linear Mode
