![]() |
#2
|
|||
|
|||
![]()
I made up the rods from 3/16 plain steel rod, only the cross drilling for the cotter pin required a bit of care.
The washer was a standard SAE #10. The springs can be cut from bulk spring material, "off the shelf" made by Century Spring (part R-10 OD .312, wire .048 pitch 086 sold in 36" lengths that I cut to match the originals I had at 2-5/8 free length). In the photo, from left to right an original (in good shape), the disassembled original I worked from to make repros before I found the good original and a repro. |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wanted: 2pdr anti tank cocking handle latch. | kevin powles | For Sale Or Wanted | 0 | 29-09-17 11:40 |
FAT roof hatch latch | Harlé Sylvain | The Softskin Forum | 4 | 01-12-16 18:30 |
Wanted: GM 590389 Lever, gearshift reverse latch finger | Jordan Baker | For Sale Or Wanted | 6 | 29-04-14 00:07 |
CMP hood latch needed ......... | BCBlitz | For Sale Or Wanted | 3 | 21-05-09 03:37 |
Carrier Stowage Locker Latch For Sale | Jordan Baker | For Sale Or Wanted | 0 | 30-07-08 03:24 |