|
|
#11
15-11-21, 08:40
|
||||
|
||||
So one end will be bolted to the existing 4 bolt conn on the hyd pump shaft and the other I am machining up the bolt straight to the engine flywheel. I have a flex plate in the photo only for hole spacing. I still need to make a plate that will bolt to the bell housing/Hyd pump and floor then that will take care of the engine area, apart from the radiator and fan.
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Door Resto | Barry Churcher | The Restoration Forum | 13 | 15-05-22 16:36 |
| FAT cab 13 No 9 resto | Mrs Vampire | The Softskin Forum | 27 | 29-09-21 07:11 |
| C15A resto | harrygrey382 | The Restoration Forum | 9 | 08-06-15 10:40 |
| another CAN m37 resto | Steve Wilson | The Restoration Forum | 11 | 25-08-12 16:57 |
| m 37 resto in new brunswick | pauljboudreau | Post-war Military Vehicles | 118 | 07-03-11 23:29 |
Threaded Mode