|
|
#1
17-06-13, 15:32
|
||||
|
||||
235 timing?
Does any one have the spec for the timing of a 235 engine?
Gilles 
|
|
#2
17-06-13, 17:19
|
|||
|
|||
|
I go with TDC. The timing mark should stand out on the flywheel.
|
|
#3
17-06-13, 23:42
|
|||
|
|||
|
If you are asking for information on the early 235 splash feed engine, according to my TM the initial timing is 5 degrees B.U.D.C.
If using a timing light the setting is 'steel ball set in the flywheel to be on the pointer'. TM 10-1557 1-1/2 ton 4x4 Chevrolet truck built for US Army. If it's the later engine, I can't help. David
__________________
Hell no! I'm not that old!
|
|
#4
18-06-13, 00:52
|
|||
|
|||
|
Later 235 Engine Manual
Hi
If you need the information on the later pressure lubrication 235 here is a link the engine manual pages http://www.canadianmilitarypattern.c...e%20Manual.htm Cheers Phil
__________________
Phil Waterman `41 C60L Pattern 12 `42 C60S Radio Pattern 13 `45 HUP http://canadianmilitarypattern.com/ New e-mail Philip@canadianmilitarypattern.com
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Recommendation for digital timing light/rpm meter | Stuart Fedak | The Restoration Forum | 12 | 07-04-12 06:12 |
| M38A1 timing...? | Casey B | Post-war Military Vehicles | 22 | 05-02-12 02:54 |
| flathead timing marks. | kevin powles | The Carrier Forum | 2 | 24-09-09 05:16 |
| Problems with site timing out | Phil Waterman | TAC HQ | 3 | 24-02-08 22:20 |
| 235 timing ? | rampant rivet | The Restoration Forum | 5 | 02-11-06 22:17 |
Linear Mode
