|
|
|
|
#1
13-12-17, 07:51
|
||||
|
||||
This part is the riser in between the sump and the crank case.
|
|
#2
13-12-17, 07:53
|
||||
|
||||
|
This is certainly going to add some extra weight.
|
|
#3
13-12-17, 07:56
|
||||
|
||||
|
I had to be relatively spot on to get the pipes and oil pump in the exact location.
|
|
#4
13-12-17, 07:58
|
||||
|
||||
|
Just as well for me that most of the surfaces were flat and not too many curves like the bottom of the trans.
|
|
#5
13-12-17, 08:01
|
||||
|
||||
|
I think I got a bit out of sequence there
|
|
#6
13-12-17, 08:03
|
||||
|
||||
|
And a general put together to make sure everything lines up.
|
|
#7
13-12-17, 08:08
|
||||
|
||||
|
It does all sit together very well but that does not mean the whole thing won't vibrate like mad when running. I am only guessing that it should run like the original parts as the crank shaft is bolted to the crank case and there are no bearings connected to the parts I have made so I am crossing my fingers that all will be well. Anyway that's about it for the engine parts I needed to make and I can get on with the internals as I only have just over a week left before we go on holidays.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Door Resto | Barry Churcher | The Restoration Forum | 13 | 15-05-22 16:36 |
| FAT cab 13 No 9 resto | Mrs Vampire | The Softskin Forum | 27 | 29-09-21 07:11 |
| C15A resto | harrygrey382 | The Restoration Forum | 9 | 08-06-15 10:40 |
| another CAN m37 resto | Steve Wilson | The Restoration Forum | 11 | 25-08-12 16:57 |
| m 37 resto in new brunswick | pauljboudreau | Post-war Military Vehicles | 118 | 07-03-11 23:29 |
Hybrid Mode
