VICKERS MK6B's resto

[colin jones]

Of course the picture are about face. Anyway after the disc is welded to the small shaft I will need to face it off on the lathe and then drill, dowell and bolt the clutch housing to the end. There will be some serious torque on this part.

[David Herbert]

Colin,
What are the dozen or so small holes drilled radially half way along the shaft ? I did wonder if they were related to the indexing of the gear teeth but although it is hard to see, I think there are less holes than teeth so not that.

David

[colin jones]

Spot on David, they were for indexing. I was going to machine them off but as it made no difference I thought I would just leave them there. All the other gears had them too but needed to be machined off.
Colin!

[Andrew Rowe]

Not to hijack your thread, but his name is NED! , Cheers Andrew.

[David Dunlop]

Well, that’s two of your crew accounted for now, Colin.

David

[David Herbert]

Should post boxes have a thread of their own ?

Hanno, please delete this if you want !

David

[colin jones]

Andrew, is that in Aussie Ned or a Kiwi Ned.
David, any suggestions for the third.

Back to the serious stuff I have completed the centre shafts that hold the bearings for the gears. I have changed the design as the original is very complicated and from what I can see is unnecessary. The material used is the same as the gears but I won't be getting them hardened as they don't move at all.