steering cam control plate

[Lynn Eades]

in service the cross tube only travels 3/8" from center to full travel each way, so the cam plate does not travel far enough as to have the rollers drop off the corners of the cam plate. The bolts go up from the bottom, at least for two of them because they thread into the short angle irons on the div. plate line.

[Daniel Bowman]

I just reassembled my cam plate this winter. I would suggest (like I did) jack the carrier up and put on proper jack stands so the pressure is off of the tracks. and check operation from there. I had taken the cross shaft out, thoroughly cleaned it, removed all the rust, cleaned and re-greased the cross tube rollers. New bearing in the cam plate (common GM sized bearing) and it warps the track as it should. I will come clean and state the I haven't driven the carrier yet (just put the engine in) but I believe its good to go.