![]() |
#14
|
|||
|
|||
![]()
...a 235 cubic inch...... you will need to look up the serial number by the machined pad leftor rear of the dizzy...
Look directly above the starter motor...... if you see two vertical raised bars....aka aptain's bar,,,, about an inch long raised casting.... thenyou are lucky and have larger 261....... Any CMP 216 right hand drive bellhousing will fit that engine.... Good luck.... don't forget to take lots of pictures and share them on MLU. Bob
__________________
Bob Carriere....B.T.B C15a Cab 11 Hammond, Ontario Canada |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
16" 8 bolt Split Rims for 1.5 ton Australian Chevrolet Trucks | Philippe Jeanneau | The Softskin Forum | 66 | 13-08-20 15:17 |
Other Wheel Options for Early Chevrolet 1.5 ton Trucks... | Philippe Jeanneau | The Softskin Forum | 5 | 01-07-19 01:42 |
10 bolt Front Hubs for 1.5 ton Australian Chevrolet Trucks 1940-1945 | Philippe Jeanneau | The Softskin Forum | 0 | 31-03-19 17:13 |
1938 Chevrolet 15-cwt G/S trucks | David_Hayward (RIP) | The Softskin Forum | 9 | 15-09-06 02:44 |
CC60L Chevrolet Modified Conventional Trucks | robbi7 | The Softskin Forum | 23 | 14-05-04 14:28 |