|
|
|
|
#1
29-04-12, 13:34
|
|||
|
|||
Kevin. I think you will find these old fords used a special profile belt (as Richard has aluded to) I have an original belt here, Autolite 7RA 8620C the belt width is 17mm wide, but the depth is 13mm (a B section is 11mm)
I think this will mean the angles of the side of the belts are different. To do it right, you might have to go to the trouble of getting belts from a Ford dealer (e.g. Vanpelts in the U.S)
__________________
Bluebell Carrier Armoured O.P. No1 Mk3 W. T84991 Carrier Bren No2.Mk.I. NewZealand Railways. NZR.6. Dodge WC55. 37mm Gun Motor Carriage M6 Jeep Mb #135668 So many questions.... 
|
|
#2
29-04-12, 20:06
|
||||
|
||||
|
belts
Hi, Lynn, Richard, I will check out what i have here and make sure its correct.
kevin.
__________________
2pdr Tank Hunter Universal Carrier 1942 registered 11/11/2008. 3" Mortar Universal Carrier 1943 registered 06/06/2009. 1941 Standard Mk1 stowage Carrier, Caunter camo. 1941 Standard Mk1 stowage Carrier, light stone. 10 cwt wartime mortar trailer. 1943 Mk2 Daimler Dingo. 1943 Willys MB. 1936 Vickers MG carrier No1 Mk1 CMM 985.
|
|
#3
30-04-12, 08:26
|
|||
|
|||
|
Did the belts on a mates carrier a few months ago. Didn't have any trouble getting them here in little old New Zealand.
__________________
1967 Land Rover Plant Repair Vehicle 1941 Matchless G3L 194? Wiles Junior Trailer 1941 Morris Commercial CS8
|
|
#4
30-04-12, 11:36
|
||||
|
||||
|
my experience with this is to check the insides of the pulleys very very carefully the slightest burr or bit off crap and you will eat through belts..... there is always the issue with over tension but knowing how anal (meant as compliment mate) you are Kev i doubt you would have done this
__________________
is mos redintegro __5th Div___46th Div__ 1942 Ford Universal Carrier No.3 MkI* Lower Hull No. 10131 War Department CT54508 (SOLD) 1944 Ford Universal Carrier MkII* (under restoration). 1944 Morris C8 radio body (under restoration).
|
|
#5
02-05-12, 00:05
|
|||
|
|||
|
My carrier chewed up a fan belt last summer, and with the Chevy 350 setup there is only the one. Noticed the temperature guage climbing and shut her down in time to avoid damage. They do get very hot very quick as there is little natural airflow over the radiator.
|
|
#6
02-05-12, 00:10
|
|||
|
|||
|
Head Gasket
We had a problem with our Lynx out here and it came down to the fact that the head gaskets fit on both ways, right and wrong! It's not that obvious I'm told which end goes where but on an old flathead forum there was an answer and it cured the overheating problem but not before we heated it up pretty good trying to sort out belts, pulleys thermostats etc.
|
 |
|
|
Hybrid Mode
