|
|
#5
16-06-12, 05:22
|
|||
|
|||
IMG-20120615-00062.jpg
Inside detail of the left rear light. IMG-20120615-00059.jpg Replacing the front portion of the floor, I can't duplicate the ribbing so I went a gauge up to make up the rigidity. IMG-20120615-00061.jpg The left rear light placement, the wiring harness had 2 wires but I believe it is just the pencil light of later CMP's with the second wire for grounding. IMG-20120615-00060.jpg Front Bulkhead was out where I could take a picture all original except for the bottom 3 inches. IMG-20120615-00058.jpg The front hitch, surge mechanism and the reverse lockup with the slotted holder for storage. Having done the breaks a CMP brake drum does fit on, Shoes and all parts from the brake cables, cylinders backing plates etc are all the same as on a 15CWT CMP. Last edited by Harry Moon; 16-06-12 at 05:41. 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| British 10-cwt trailer reference thread | Nick Bullock | The Softskin Forum | 99 | 14-07-25 23:54 |
| LP2 VR 2225 Build | Dale Jordan | The Restoration Forum | 255 | 25-07-18 07:45 |
| My GM engine number when was it build?? | 8threcce | The Restoration Forum | 7 | 09-01-12 08:39 |
| Pssst... want to build a gun tractor? | Keith Webb | The Softskin Forum | 12 | 16-07-04 00:13 |
Threaded Mode