|
|
#2
26-07-13, 15:45
|
|||
|
|||
Richard, If you mean the cross tube roller brackets, where they bolt to the hull, then they are all 3/8" BSF of various lengths.
They are all countersunk (obvious) heads. The bottom ones that go through the seal retainers, are flat head, and the upper ones are round (boss)head. They vary in length. the longer ones about 1 5/8". There is a longer one on the left side for the battery earth strap.
__________________
Bluebell Carrier Armoured O.P. No1 Mk3 W. T84991 Carrier Bren No2.Mk.I. NewZealand Railways. NZR.6. Dodge WC55. 37mm Gun Motor Carriage M6 Jeep Mb #135668 So many questions.... Last edited by Lynn Eades; 27-07-13 at 03:02. 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Bolt question | Svenn Ryen | Auction and Classified Ad Site Heads Up | 16 | 07-04-18 13:21 |
| CMP Tire sizes? | Pedro Bedard | The Softskin Forum | 22 | 17-06-16 19:58 |
| Spring Lengths | ajmac | The Carrier Forum | 7 | 28-06-13 20:28 |
| Question: tap and die set sizes | Hanno Spoelstra | The Restoration Forum | 8 | 21-12-10 21:01 |
| Tyre sizes | Little Jo | The Softskin Forum | 13 | 15-12-10 13:53 |
Threaded Mode