For Sale: Carrier downpipes second run

[kevin powles]

Gents, Those who have expressed an interest in the down pipes, I have ordered and paid for the laser cut flanges and pipe bends.

The following people want them.

Richard x 1 set, already paid, (picked your flanges up today, perhaps go for some new stainless?, additional £20)
Ben x 1 set. CASH PAYMENT ARRANGED.
Rick x 1 set, already paid.
Fred R X 3 sets. paid
Meduffer x 1 set.
Carrier Barry x 1 set.
Nick Bullock x 1 set. PAID.
Me x 2 sets. PAID.
Neil Ashley x 1 set paid
They are working out at £65 a set. One set left up for grabs on this run.

Kevin.

Please Paypal / cheque / bank transfer me ASAP, 'money owed' payment if using Paypal.

[Stew Robertson]

Just a wee tip
your pipes should be undersized then enlarged again at the end
or with the engine movement you make break the manifolds
also why the heavy duty flanges I think they should be 1/4 inch
it makes them easier to install without taking the studs out
Just my opinion (Again) !
I also recognize those hands cutting them off

[kevin powles]

Originally Posted by Stew Robertson

Just a wee tip
your pipes should be undersized then enlarged again at the end
or with the engine movement you make break the manifolds
also why the heavy duty flanges I think they should be 1/4 inch
it makes them easier to install without taking the studs out
Just my opinion (Again) !
I also recognize those hands cutting them off

Hi Stew, Valid points, what I have found with the bottom castings is that after 70 odd years they can vary in inside diameter vastly, once cleaned up, grit blasted etc, if you were to have the ends produced and sent to you as per original spec they may well rattle around in there, so its up to the individual to finish the ends to suit there casting. I think you can still fit a nut on the original studs?, these are thicker as I have seen a lot of warped flanges, but only by 5mm.

Kevin.

[RichardT10829]

Kevin matey, did you post the bits in the end, as nothing has arrived yet ? Just concerned in case they have been swallowed up by the postal machine :-)

[kevin powles]

Originally Posted by RichardT10829

Kevin matey, did you post the bits in the end, as nothing has arrived yet ? Just concerned in case they have been swallowed up by the postal machine :-)

Rich, not yet, only picked up the flanges today, going to be a couple of weeks to fit in with work and family.

Kevin.

[Neil Ashley]

Kevin

I should get upthe bank tommorrow.

I asume you have missed the word set off the end of my requirements.

[kevin powles]

Richard x 1 set, already paid, POSTED
Ben x 1 set. Paid. delivered
Rick x 1 set, paid. POSTED.
Fred R X 3 sets. POSTED.
Meduffer x 1 set. paid, posting Monday.
Carrier Barry x 1 set.
Nick Bullock x 1 set. paid. posting Monday.
Neil Ashley x 1 set posting Monday.
These are get done slowly so thanks for your patience

Kevin.