C8A HUW: body dimensional data needed

[Phil Waterman]

Hi Jerry

I started making Angle Measurements couple of samples below. They are not as readable as the should be so I'll work on the lighting so that not getting reflection off the scale. Also need to be sure picture is square to the needle.

Measured both my HUP and Pat 13 C60S and it looks like the angle of the windscreen is the same on both.

One thing I noted on the first pass through measuring and figuring out how to make measurements relative to true level. My shop floor is nearly dead level, but the HUP has a slight nose down angle.

The took some preliminary measurements on the front door openings on my HUP not surprisingly they are not identical +/- 1/8 inch.

Window Post Driver Side
WCMP HUP Angle Measurements 019.jpg

Door Post at Latch on C60S -
W CMP HUP Angle Measurements 003.jpg

Floor of HUP at Drivers Seat
CMP HUP Angle Measurements 012.jpg

Top of Window Post Roof Line
WCMP HUP Angle Measurements 030.jpg

Measuring across door opening
WCMP HUP Angle Measurements 040.jpg

I think to make these really useable once the reflection problem is solved I'll post them on my web site with both small image and full resolution click it.


Cheers Phil