|
|
#20
29-06-16, 00:57
|
|||
|
|||
Morri
I have measured the recess for the pistons and there is more than 1/16,"the pistons are .010" below the top of the case and there is .130" at the lowest on the head as it domes up over the pistons(which are flat) this is before I add the gasket which I didn't measure as it will be flattened by tightening down the head. Will do a pressure test once I get it all back together.
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Morris PU pic | Mike K | The Softskin Forum | 6 | 17-05-24 05:56 |
| Morris C4 | Rolf S. Ask | The Softskin Forum | 3 | 06-09-11 15:29 |
| Morris LRC | Neil Ashley | The Armour Forum | 0 | 06-02-08 18:22 |
| Morris ces | 25pdrfg | The Restoration Forum | 0 | 02-12-07 19:48 |
| 'Morris'? | David_Hayward (RIP) | The Softskin Forum | 2 | 01-12-05 18:01 |
Threaded Mode