An Introduction: Chris Collins and Morris Tilly Project

[jack neville]

A couple of other modified pieces from damaged roofs were also removed to be fitted into the new roof. All the timber pieces will need to be replicated from the intact originals. Then all the pieces will be sand blasted before being reassembled. So out of four authentic Tilly rooves, plus the car roof I can salvage and complete two Tilly rooves. Next I moved onto relocating the B pillars. The car pillars are simply relocated back to accommodate a bigger door. I cut the sill around the pillar, wiggled the pillar until the internal spotwelds gave and removed the whole lot. The gap is filled with a patch just as the originals were done. I did cut the right side a bit too long so an extra patch will be required. I wil grind up the weld so it can't be seen. The rear curved section of the pillar is cut away to square it up.